Pro-Tech EB-471LF M1 Manuel d'utilisateur télécharger pdf (Page 57)

Chapter 4 Award BIOS Setup

Page: 4-16

EB-471LF USER

′

S MANUAL

This item allows you to decide to active whether PCI Slot or on-chip

VGA first.

SUPER IO DEVICE:

The options for these items are found in its sub menu. By pressing the

<ENTER> key, you are prompt to enter the sub menu of the detailed options

as shown below:

Phoenix – Award CMOS Setup Utility

SuperIO Device

Item Help

Onboard FDC Controller

Onboard Serial Port 1

Onboard Serial Port 2

UART Mode Select

X RxD, TxD Active

X IR Transmission Delay

X UR2 Duplex Mode

X Use IR Pins

[Enabled]

[3F8/IRQ4]

[2F8/IRQ3]

[Normal]

Hi, Lo

Enabled

Half

IR-Rx2Tx2

Menu Level ►

↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5: Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults

Descriptions on each item above are as follows:

1. Onboard FDC Controller

Select Enabled if the system has a floppy disk controller (FDC) installed

on the system board and you wish to use it. If you install and-in FDC or

the system has no floppy drive, select Disabled.

2. Onboard Serial Port 1/2

Select an address and corresponding interrupt for the first and second

serial ports.

3. UART Mode Select

This item allows you to select UART mode.

4. RxD, TxD Active

This item allows you to determine the active of RxD, TxD.

5. IR Transmission Delay

This item allows you to enable/disable IR transmission delay.

6. UR2 Duplex Mode

This item allows you to select the IR half/full duplex function.

7. Use IR Pins

This item allows you to select IR transmission routes, one is RxD2m,

TxD2 (COM Port) and the other is IR-Rx2Tx2

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Pro-Tech EB-471LF M1 Manuel d'utilisateur Page 57

Commentaires sur ces manuels